MYP Physics · topic MYP-06.03
Particle model and states of matter
Connect the ideas, make your working visible, and test the result. Use the hints when you need a starting point; open the full solution after your attempt.
Extra challenging questions
Work through the linked stages and explain what each result means.
Heating ice while heat escapes
Optional enrichment: this challenge may extend beyond the usual syllabus depth and assumes confidence with algebra and graph interpretation. A 0.10 kg sample of ice begins at 0°C. A heater supplies 100 W, while a separate calibration shows a constant 20 W loss to the surroundings during this experiment. The sample-temperature observations are supplied below. Use latent heat of fusion 3.36×10⁵ J kg⁻¹ and water specific heat capacity 4200 J kg⁻¹ K⁻¹. Ignore vessel heat capacity. Supplied data (Time / s; Temperature / °C): (0, 0), (210, 0), (420, 0), (525, 20). (a) Predict the melting duration and then the time to reach 20°C after melting. Check both against the data. [3 marks] (b) Explain the constant-temperature interval with a particle model and evaluate a calculation that ignores losses. [3 marks]
Observed heating curve
Supplied question data. Read the labelled axes and use the observations to test the physical model.
Vertical axis (y): Temperature / °C
Horizontal axis (x): Time / s
Read the exact data as a table
| Time / s | Temperature / °C |
|---|---|
| 0 | 0 |
| 210 | 0 |
| 420 | 0 |
| 525 | 20 |
These are the supplied values, not a worked answer. Lines join the supplied values; they are not a fitted model.
Show a hint
Begin with part (a): Predict the melting duration and then the time to reach 20°C after melting. Check both against the data.
Reveal the worked solution
- Net heating power is 100−20 = 80 W, since the sample does not receive the full heater input.
- Melting needs mL = 0.10(3.36×10⁵) = 33600 J; duration is 33600/80 = 420 s.
- Warming liquid by 20 K needs mcΔT = 0.10(4200)(20) = 8400 J; duration is 8400/80 = 105 s. Both match the supplied curve.
- During melting, transferred energy changes intermolecular potential energy rather than increasing mean kinetic energy, so temperature need not rise.
- The internal energy still increases through the phase change; temperature is not a measure of the total internal energy.
- Ignoring losses gives 33600/100 = 336 s, 84 s too short. Insulation and a lid can reduce unwanted transfers; repeats alone do not remove systematic heat loss.
Answer (a) Melting takes 420 s; subsequent warming takes 105 s. (b) Temperature stays constant while internal energy increases through a change in particle arrangement; ignoring losses underestimates the required time.
Compare the assumptions, method and units with your attempt. Explain any correction before trying another question.